Cisco ME 3400 - Policy-Map

2-327
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
policy-map
policy-map
Use the policy-map global configuration command to create or to modify a policy map that can be
attached to multiple physical ports and to enter policy-map configuration mode. Use the no form of this
command to delete an existing policy map.
policy-map policy-map-name
no policy-map policy-map-name
Syntax Description
Defaults No policy maps are defined. By default, packets are sent unmodified.
Command Modes Global configuration
Command History
Usage Guidelines The switch supports a maximum of 256 unique policy maps.
Before configuring policies for classes whose match criteria are defined in a class map, use the
policy-map command to specify the name of the policy map to be created or modified. Entering the
policy-map command also enables the policy-map configuration mode, in which you can configure or
modify the class policies for that policy map.
After entering the policy-map command, you enter policy-map configuration mode, and these
configuration commands are available:
• class: the specified traffic classification for which the policy actions are applied. The classification
is defined in the class-map global configuration command. For more information, see the
class-map
command.
• description: describes the policy map (up to 200 characters).
• exit: exits policy-map configuration mode and returns to global configuration mode.
• no: removes a previously defined policy map.
Note If you enter the no policy-map configuration command or the no policy-map policy-map-name global
configuration command to delete a policy map that is attached to an interface, a warning message
appears that lists any interfaces from which the policy map is being detached. The policy map is then
detached and deleted. For example:
Warning: Detaching Policy test1 from Interface GigabitEthernet0/1
policy-map-name Name of the policy map.
Release Modification
12.2(25)EX This command was introduced.