Cisco ME 3400 - Debug Ip Sla Error Twamp Control Reflector

B-14
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Appendix B Cisco ME 3400 Ethernet Access Switch Debug Commands
debug ip sla error twamp control reflector
debug ip sla error twamp control reflector
Use the debug ip sla error twamp control reflector command in privileged EXEC mode to enable
debugging output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement
Protocol (TWAMP) showing exceptions during communication between the TWAMP server and
reflector. Use the no form of this command to disable debugging output.
debug ip sla error twamp control reflector
no debug ip sla error twamp control reflector
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines The debug ip sla error twamp control reflector privileged EXEC command displays messages about
exceptions that occurred during communications sent from the TWAMP session reflector to the TWAMP
session server.
Note Use the debug ip sla error twamp control reflector command before using the debug ip sla trace
twamp control reflector command because the debug ip sla error twamp control reflector command
generates less debugging output.
The debug ip sla error twamp control reflector command is supported in IPv4 networks.
The undebug ip sla error twamp control reflector command is the same as the no debug ip sla error
twamp control reflector command.
Related Commands
Release Modification
12.2(52)SE This command was introduced.
Command Description
debug ip sla error twamp
connection
Displays exceptions during communication between the IP SLAs
TWAMP client and server.
debug ip sla error twamp
control server
Displays exceptions during communication between the IP SLAs
TWAMP server and reflector.
debug ip sla error twamp
session
Displays exceptions during communication between the IP SLAs
TWAMP sender and reflector.
debug ip sla trace twamp
connection
Displays the normal communications between an IP SLAs TWAMP
client and server.
debug ip sla error twamp
control reflector
Displays the normal communications sent by an IP SLAs TWAMP
reflector to the TWAMP server.