2-189
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
ip sla responder twamp
ip sla responder twamp
Use the ip sla responder twamp global configuration command to configure the switch as a Two-Way
Active Measurement Protocol (TWAMP) responder. Use the no form of this command to disable the IP
SLA TWAMP responder.
ip sla responder twamp [timeout seconds]
no ip sla responder twamp [timeout seconds]
Syntax Description
Defaults No IP SLA TWAMP responder is configured.
Command Modes Global configuration
Command History
Usage Guidelines After entering the ip sla responder twamp command, you enter IP SLA TWAMP reflector configuration
mode, and these configuration commands are available:
• default: sets a command to its defaults.
• exit: exits from IP SLA TWAMP reflector configuration mode.
• no: negates a command or resets to its defaults.
• timeout seconds: specifies the maximum time the session can be inactive before the session ends.
The range is 1-604800 seconds. The default is 900 seconds.
For the TWAMP server and reflector to function, you must also configure a TWAMP control device,
which serves as the client and session sender. These functions are not configured on a Cisco device.
Examples This example shows how to configure a switch as an IP SLA TWAMP responder:
Switch(config)# ip sla responder twamp
Switch(config-twamp-ref)# timeout inactivity 900
timeout seconds (Optional) Specify the number of seconds a TWAMP session can be inactive
before the session ends. The range is 1-604800 seconds. The default is 900
seconds.
Release Modification
12.2(52)SE This command was introduced.
To Next Page
Loading...
