Cisco ME 3400 Command Reference

B-11
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Appendix B Cisco ME 3400 Ethernet Access Switch Debug Commands
debug ip igmp snooping
debug ip igmp snooping
Use the debug igmp snooping privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) snooping activity. Use the no form of this command to disable debugging.
debug ip igmp snooping [group | management | querier | router | timer]
no debug ip igmp snooping [group | management | querier | router | timer]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ip igmp snooping command is the same as the no debug ip igmp snooping command.
Related Commands
group (Optional) Display IGMP snooping group activity debug messages.
management (Optional) Display IGMP snooping management activity debug messages.
querier (Optional) Display IGMP snooping querier debug messages.
router (Optional) Display IGMP snooping router activity debug messages.
timer (Optional) Display IGMP snooping timer event debug messages.
Release Modification
12.2(25)EX This command was introduced.
Command Description
debug platform ip
igmp snooping
Displays information about platform-dependent IGMP snooping activity.
show debugging Displays information about the types of debugging that are enabled.

Cisco ME 3400 Specifications

General

Category	Switch
Rack Mountable	Yes
Jumbo Frame Support	Yes
Authentication Method	RADIUS, TACACS+
RAM	128 MB
Flash Memory	32 MB
Power Device	Internal power supply
Model	ME 3400
Layer	Layer 2
MAC Address Table Size	8000 entries
Remote Management Protocol	SNMP, Telnet, SSH, HTTP, HTTPS
Features	VLAN support, IGMP snooping, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1D, IEEE 802.1Q, IEEE 802.3ab, IEEE 802.3x
Memory	128 MB
Power Supply	AC 120/230 V (50/60 Hz)
Dimensions (H x W x D)	4.4 cm x 44.5 cm x 24.2 cm
Routing Protocol	Static routing