2-482
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
show ip sla twamp connection
show ip sla twamp connection
Use the show ip sla twamp connection command in user EXEC mode to display the current Cisco IOS
IP Service Level Agreements (SLAs) Two-Way Active Measurement Protocol (TWAMP) connections.
show ip sla twamp connection {detail [source-ip ip-address] | requests} [ | {begin | exclude |
include} expression]
Syntax Description
Defaults Displays output for all running IP SLAs TWAMP sessions.
Command Modes User EXEC
Command History
Usage Guidelines Use the detail keyword to display detailed information for a single IP SLAs TWAMP connection.
Use the requests keyword to display the current IP SLAs TWAMP connection requests.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples The following is sample output from the show ip sla twamp connection detail command:
Switch> show ip sla twamp connection detail
Connection Id: 91
Client IP Address: 172.27.111.225
Client Port: 43026
Mode: Unauthenticated
Connection State: Connected
Control State: None
Number of Test Requests - 0:1
detail Display current connection details.
source-ip ip-address (Optional) Display connection details from a specific TWAMP connection.
requests Display current connection requests.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(52)SE This command was introduced.
To Next Page
Loading...
