2-53
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
clear spanning-tree counters
clear spanning-tree counters
Use the clear spanning-tree counters privileged EXEC command to clear the spanning-tree counters.
clear spanning-tree counters [interface interface-id]
Syntax Description
Defaults No default is defined.
Command Modes Privileged EXEC
Command History
Usage Guidelines If the interface-id is not specified, spanning-tree counters are cleared for all STP ports.
Examples This example shows how to clear spanning-tree counters for all STP ports:
Switch# clear spanning-tree counters
Related Commands
interface interface-id (Optional) Clear all spanning-tree counters on the specified interface. Valid
interfaces include physical network node interfaces (NNIs), enhanced
network interfaces (ENIs) on which spanning tree has been enabled, VLANs,
and spanning-tree port channels. The VLAN range is 1 to 4094. The
port-channel range is 1 to 48.
Note Spanning Tree Protocol (STP) is not supported on user network
interfaces (UNIs). Though visible in the command-line help, the
command has no effect on UNIs or on ENIs on which STP is not
enabled.
Release Modification
12.2(25)EX This command was introduced.
Command Description
show spanning-tree Displays spanning-tree state information.
To Next Page
Loading...
