2-510
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
show logging onboard
show logging onboard
Use the show logging onboard privileged EXEC command to display the on-board failure logging
(OBFL) information.
show logging onboard [module [slot-number]] {{clilog | environment | message |temperature |
uptime | voltage} [continuous | detail | summary] [start hh:mm:ss day month year] [end
hh:mm:ss day month year]} [ | {begin | exclude | include} expression]
Syntax Description
Defaults There is no default.
Command Modes Privileged EXEC
Command History
module [slot-number] (Optional) The module slot number is always 1 and is not relevant for
the ME-3400.
clilog Display the OBFL CLI commands that were entered on the switch.
environment Display the unique device identifier (UDI) information for the switch
and for all the connected devices: the product identification (PID), the
version identification (VID), and the serial number.
message Display the hardware-related system messages generated by the switch.
temperature Display the temperature of the switch.
uptime Display the time when the switch starts, the reason the switch restarts,
and the length of time the switch has been running since it last
restarted.
voltage Display the system voltages of the switch.
continuous (Optional) Display the data in the continuous file. For more
information, see the “Usage Guidelines” section.
summary (Optional) Display the data in the summary file. For more information,
see the “Usage Guidelines” section.
start hh:mm:ss day month
year
(Optional) Display the data from the specified time and date. For more
information, see the “Usage Guidelines” section.
end hh:mm:ss day month year (Optional) Display the data up to the specified time and date. For more
information, see the “Usage Guidelines” section.
detail (Optional) Display both the continuous and summary data.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(44)EY This command was introduced.
To Next Page
Loading...
