Cisco ME 3400 - Page 226

2-198
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
ip sticky-arp (global configuration)
• Use the no sticky-arp global configuration command to disable sticky ARP on the switch.
• Use the no sticky-arp interface configuration command to disable sticky ARP on an interface when
sticky ARP is disabled on the switch.
Examples To disable sticky ARP:
Switch(config)# no ip sticky-arp
You can verify your settings by using the show arp privileged EXEC command.
Related Commands Command Description
arp Adds a permanent entry in the ARP table. For syntax information,
see the Cisco IOS IP Addressing Services Command Reference,
Release 12.4 > ARP Commands.
show arp Displays the entries in the ARP table. For syntax information, see the
Cisco IOS IP Addressing Services Command Reference,
Release
12.4 > ARP Commands.