Cisco Nexus 7000 Series - Connecting a 1000 BASE-T Port to the Network; Connecting or Disconnecting a 1000 BASE-T Port

Send document comments to nexus7k-docfeedback@cisco.com
6-8
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 6 Connecting the Cisco Nexus 7000 Series Switch to the Network
Connecting an I/O Module
This section includes the following topics:
• Connecting or Disconnecting a 1000BASE-T Port, page 6-8
• Connecting or Disconnecting an SFP, SFP+, or X2 Port, page 6-9
Connecting or Disconnecting a 1000BASE-T Port
This section includes the following topics:
• Connecting a 1000BASE-T Port to the Network, page 6-8
• Disconnecting a 1000BASE-T Port from the Network, page 6-9
Connecting a 1000BASE-T Port to the Network
You can connect a copper network interface cable with an RJ-45 connector to a port on a 48-port
10/100/1000 Ethernet I/O module (N7K-M148GT-11 and N7K-M148GT-11L).
32-port 1- /10-Gigabit Ethernet (N7K-F132XP-15) SFP
1000BASE-T
SFP+
GLC-LH-SM
GLC-LH-SMD
GLC-SX-MM
GLC-SX-MMD
GLC-ZX-SM
SFP-GE-L
SFP-GE-S
SFP-GE-Z
GLC-T
SFP-GE-T
SFP-10G-LR
2
SFP-10G-LRM
SFP-10G-SR
SFP-H10GB-CUxM
2
SFP-H10GB-ACUxM
Fiber optic
Copper
Fiber optic
Copper
8-port 10-Gigabit Ethernet (N7K-M108X2-12L) 10GBASE-X
X2
X2-10GB-ER
X2-10GB-LR
X2-10GB-LRM/
X2-10GB-LX4
X2-10GB-SR
X2-10GB-ZR
X2-10GB-CX4
DWDM-xxxx
Fiber optic
Copper
Copper
1. FETs are used only when connecting this I/O module to a Fabric Extender (FEX).
2. Requires Version 2 or later version.
3. Requires Version 2 or later version.
Table 6-1 Connectors and Cables Supported by I/O Modules (continued)
Module Port Type Connector/Transceiver Cable Type