Send document comments to nexus7k-docfeedback@cisco.com
9-14
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing a Supervisor Module
Figure 9-4 Removing the Plastic Protector from the Supervisor Module
Caution To prevent ESD damage, avoid touching the electronic circuitry and prevent anything else from coming
in contact with the circuitry.
Step 3 On the currently installed supervisor module (the module that you are going to remove), loosen the two
captive screws identified in View A of Figure 9-5.
To Next Page
Loading...
