Cisco Nexus 7000 Series - Page 287

Send document comments to nexus7k-docfeedback@cisco.com
9-65
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 9 Replacement Procedures
Replacing the Front Door and Air Intake Assemblies on the Cisco Nexus 7018 Chassis
Figure 9-36 Packing the Front Door
g.
Fold the short side flaps of the box over the top and bottom ends of the door.
h. Fold the wider side flaps of the box over the door and tape them together.
i. Loosen and remove the eight screws holding the bottom hinge bracket for the door. Four of the
screws are attached to the left and right side of the cable management frame (two screws on each
side) and four of the screws are attached to the chassis (see Figure 9-37). Place the screws in the
small parts bag.
1 Align the two shorter side cushions to the
shorter inside crease in the center panel of the
box.
4 Fold the two short flaps up along the end side
cushions and then fold them over the top of
the front door.
2 Align the two longer side cushions to the
longer inside crease in the center panel of the
box.
5 Fold the two long flaps up along the side
cushions and then fold them over the top of
the side flaps and door.
3 Place the door in the open space between the
side cushions.
6 Tape the two long flaps together and to the
box with packing tape.