Send document comments to nexus7k-docfeedback@cisco.com
2-14
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-06
Chapter 2 Installing a Cisco Nexus 7009 Chassis
Installing the Chassis
Figure 2-5 Moving a Cisco Nexus 7009 Chassis onto a Rack (Front-Mount Installation)
Step 4
Make sure that the screw holes in the chassis mounting brackets align with the screw holes in the vertical
mounting rails.
Tip To adjust the placement of the chassis so that the screw holes in the chassis mounting brackets align with
the screw holes in the vertical mounting rails, use the chassis handles shown in Figure 2-6.
Step 5 Use a Phillips screwdriver to screw in seven to eight M6 x 19-mm or 12-24 x 3/4-inch screws in each of
the two chassis vertical mounting brackets (use a total of 12 to 14 screws for each of two mounting
brackets) as shown in Figure 2-6.
1 Push the lower half of the front side of the chassis 3 Rack with vertical mounting rails
2 Front-mounting brackets
To Next Page
Loading...
