Figure 4: Clearances Required Around the Chassis
Chassis width9Chassis1
No right side clearance required (no airflow on right
side)
10Cable management frames2
Rear service clearance required to replace fan trays
and fabric modules
11Vertical rack-mount posts and rails3
Airflow clearance area required at the rear of the
chassis within the cabinet (if a cabinet is used)
12Area used for fan tray handles at the rear
of the chassis (allow 2 inches [5 cm])
4
Cisco Nexus 7706 Hardware Installation Guide
OL-31330-0112
Preparing the Site
Clearance Requirements
To Next Page
Loading...
