Cisco Nexus 7706 - Reloading a Module; Rebooting the Switch

Reloading a Module
You can reset a module by using the reload module command and specifying the module by its slot number
in the chassis.
Reloading a module disrupts traffic through the module.
Caution
Step 1 Enter the configure terminal command to enter the configuration terminal mode.
Example:
switch# configure terminal
switch(config)#
Step 2 Specify the slot number for the module that you are resetting by entering the reload module slot_numbercommand.
Example:
switch(config)# reload module 1
Rebooting the Switch
To reboot or reload the switch, use the reload command without any options. When you use this command,
you reboot the switch.
If you need to use the reload command, be sure to save the running configuration by using the copy
running-config startup-config vdc-all command beforehand.
Note
Step 1 Start the configuration mode by entering the configure terminal command.
Example:
switch# configure terminal
switch(config)#
Step 2 Save the running configuration by entering the copy running-config startup-config vdc-all command.
Example:
switch(config)# copy running-config startup-config vdc-all
Step 3 Reload the switch by entering the reload command.
Example:
Cisco Nexus 7706 Hardware Installation Guide
OL-31330-0164
Managing the Switch
Reloading a Module