CHAPTER 5
Managing the Switch
• Displaying Information About Installed Hardware Modules, on page 51
• Displaying the Hardware Inventory for a Switch, on page 54
• Displaying the Backplane and Serial Number Information, on page 55
• Displaying Environmental Information for a Switch, on page 57
• Displaying Temperatures for Modules, on page 60
• Connecting to a Module, on page 62
• Saving the Module Configuration, on page 63
• Displaying Power Usage Information, on page 63
• Reloading a Module, on page 64
• Rebooting the Switch, on page 64
• Overview of Supervisor Modules, on page 65
• Overview of I/O Module Support, on page 65
• Overview of Fabric Module Support, on page 71
• Power Modes Overview, on page 73
• Overview of Fan Trays, on page 77
Displaying Information About Installed Hardware Modules
To display information about the switch hardware and the hardware modules installed in the switch chassis,
use the show hardware command.
Enter the show hardware command.
Example:
switch# show hardware
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Documents: http://www.cisco.com/en/US/products/ps9372/tsd_products_support_seri
es_home.html
Copyright (c) 2002-2013, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained in this software are
owned by other third parties and used and distributed under
license. Certain components of this software are licensed under
the GNU General Public License (GPL) version 2.0 or the GNU
Lesser General Public License (LGPL) Version 2.1. A copy of each
such license is available at
Cisco Nexus 7706 Hardware Installation Guide
51OL-31330-01
To Next Page
Loading...
