Figure 9: Attaching the Chassis to the Rack
Six M6 x 19 mm or 10-24 x 3/4 in. Phillips screws used to attach each
side bracket to a front mounting rail (use a total of 12 screws)
3Vertical mounting rails on the rack1
Eight M6 x 10 mm screws used to attach each bottom support rail to the
chassis (use a total of 16 screws for both rails)
4Mounting brackets for two-post
racks
2
Step 8 Use eight M6 x 10 mm screws to attach the bottom-support rails to the chassis (use a total of 16 screws for both bottom
support rails). See Callout 4 in the previous figure.
Step 9 If you removed any fabric modules before moving the chassis, replace each one in the chassis as follows:
a) Holding the front of the fabric module (the side with the LEDs), turn the module so that the front side is vertical.
The top of the module has an alignment bracket running from the rear to the front. The electrical connectors
will be at the bottom.
Note
b) Align the rear of the fabric module to an open fabric slot and insert the bracket on top of the module into the track
at the top of the slot.
If there are only three fabric modules to install, install them in fabric slots 1, 3, and 5.
Note
c) Slide the module part way into the slot.
d) Press the ejector button on the front of the module, to release the levers from the front of the module.
e) Rotate the levers away from the front of the module and hold them while sliding the module all the way into the
slot.
f) Simultaneously rotate both levers to the front of the module. They click when locked to the front of the module.
Step 10 If you removed any fan trays before moving the chassis, reinstall each one in the chassis as follows:
a) Holding each of the two handles on the fan tray with your two hands, align the fan tray to an open fan tray slot.
The two alignment brackets on top of the fan tray should align to two tracks at the top of the slot.
Note
b) Slide the fan tray into the slot until the front of the fan tray comes in contact with the rear of the chassis.
Cisco Nexus 7706 Hardware Installation Guide
25OL-31330-01
Installing the Switch Chassis
Installing the Chassis in a Two-Post Rack
To Next Page
Loading...
