Step 1 Attach the two cable management frames to the chassis as follows:
a) Position one of the cable management side frame assemblies on the vertical mounting bracket attached to one side
of the front of the chassis so that the following screw holes align:
• Five screw holes in the assembly should align with the screw holes in five studs on the mounting bracket (see
the following figure).
Figure 17: Attaching a Cable Management Assembly to the Chassis
M4 x 12 mm screws (three) secure the upper
portion of assembly to the mounting bracket
3Vertical mounting bracket on the chassis1
M4 x 12 mm screws (four) secure two angle
brackets to the chassis
4Cable management assembly2
• Four screw holes in the two angled brackets on the assembly should align with the four screw holes in the chassis.
If these screw holes do not align together or the angled brackets do not touch the chassis, try positioning the
assembly on the opposite side of the chassis.
b) Secure the upper portion of the frame to the chassis vertical mounting bracket with three M4 x 12 mm, flat-head,
Phillips screws. Tighten each screw to 11.5 to 15 in-lb (1.3 to 1.7 N·m) of torque.
c) Secure the bottom portion of the frame to the chassis using four M4 x 12 MM flat-head Phillips screws in the two
angled brackets on the frame. Tighten each screw to 11.5 to 15 in-lb (1.3 to 1.7 N·m) of torque.
d) Repeat Steps 1a through 1c to attach the other cable management frame to the mounting bracket on the opposite side
of the chassis.
Step 2 Attach the cable management top hood to the chassis and the tops of the two cable management side assemblies as follows:
a) Place the top hood (see Callout 1 in the following figure), with its brackets pointing down, on top of the two cable
management side assemblies.
Cisco Nexus 7706 Hardware Installation Guide
37OL-31330-01
Installing the Switch Chassis
Installing Cable Management Frames onto the Chassis
To Next Page
Loading...
