Cisco Nexus 7706 - Page 80

DescriptionI/O Module State
The module has established connection with the supervisor and the module is
performing bootup diagnostics.
testing
The diagnostics have completed successfully and the configuration is being downloaded.initializing
The switch detects a module failure upon initialization and automatically attempts to
power-cycle the module three times. After the third attempt, the module powers down.
failure
The switch is ready to be configured.ok
The switch detects insufficient power for an I/O module to power up.power-denied
This module is the active supervisor module and the switch is ready to be configured.active
The HA switchover mechanism is enabled on the standby supervisor module.HA-standby
Displaying Information for All Installed Modules
Displaying Information for a Specific Supervisor or I/O Module
Displaying Information for a Specific Fabric Module
switch# show module
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
1 48 1/10 Gbps Ethernet Module N77-M348XP-23L ok
2 24 10/40 Gbps Ethernet Module N77-M324FQ-25L ok
3 0 Supervisor Module-3 N77-SUP3E active *
4 0 Supervisor Module-3 N77-SUP3E ha-standby
5 24 10/40 Gbps Ethernet Module N77-M324FQ-25L ok
6 48 1/10 Gbps Ethernet Module N77-F348XP-23 ok
Mod Sw Hw
--- -------------- ------
1 8.3(0)SK(0.47) 0.203
2 8.3(0)SK(0.47) 0.203
3 8.3(0)SK(0.47) 0.909
4 8.3(0)SK(0.47) 0.203
5 8.3(0)SK(0.47) 0.203
6 8.3(0)SK(0.47) 0.203
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
1 50-06-ab-91-05-a0 to 50-06-ab-91-05-d3 JAE194108S6
2 00-57-d2-0a-9c-c0 to 00-57-d2-0a-9d-23 JAE194507M4
3 0c-68-03-28-d9-58 to 0c-68-03-28-d9-6a JAE172704C3
4 1c-df-0f-79-17-6d to 1c-df-0f-79-17-7f JAE171807ZJ
5 00-27-90-a1-9a-20 to 00-27-90-a1-9a-83 JAE214303MP
6 e8-ed-f3-e4-c8-e8 to e8-ed-f3-e4-c9-1f JAE17360CZA
Mod Online Diag Status
--- ------------------
1 Pass
2 Pass
Cisco Nexus 7706 Hardware Installation Guide
OL-31330-0168
Managing the Switch
Displaying Information for the Installed Modules