47
19.1. Mount the lower corner panels
Repeat the procedure on both sides.
1. Add a small bracket to the middle rail, and
fasten with a screw (M6x12).
Do not tighten the screw now. You need the
flexibility when aligning all panels later.
2. Place the corner panel onto the profiles.
Make sure to fit the groove of the panel fully onto both profiles, and
check that the slots at the rear side of the panel enters the screws with
spacers.
Profiles Screw with
spacer
Screw with
spacer
The slots at the rear side
of the panel shall enter the
screws with spacers.
Fit the panel groove fully
onto the profile
(cross section, lower corner)
To Next Page
Loading...