Cisco RV132W

Configuration Commands
wan
Cisco RV34xx Router CLI Reference Guide 41
4
Default Configuration
None.
Example
The following example displays how to add a wan using the ptm transfer mode.
router06000a>wan add service ptm --protocol bridge --vlan 55 --nat enable --igmp enable --
bindports eth3.
wan {add | edit} service eth --protocol {dhcp | static | pppoe |
l2tp | pptp}
To add or edit a wan Ethernet connection, use the wan {add | edit} service eth --
protocol {dhcp | static | pppoe | l2tp | pptp} command.
Parameter
protocol {dchp | static | pppoe | 12tp | pptp} - Select and enter the protocol.
Default Configuration
None.
Example
The following example displays how to add a wan ethernet connection.
router06000a>wan add service eth --protocol pppoe --vlan 4 --nat enable --username qacafe --
password qacafe123 --ipv6mode 6rd
wan delete service atm portid.vpi.vci --vlan vlanID
To delete a wan connection using the atm transfer mode, use the wan delete
service atm portid.vpi.vci --vlan vlanID command.
Parameter
portid.vpi.vci - Enter the port ID.
vlanID - Enter the vlan ID.