Cisco RV132W

Configuration Commands
lanhosts
Cisco RV34xx Router CLI Reference Guide 26
4
Example
The following example displays the LAN configuration for the dhcpclient.
router06000a>lan config --dhcpclient br1 enable
lan show bridge-name
To display the bridge name of the LAN, use the lan show bridge-name command.
Parameters
bridge-name - Enter the bridge name.
Default Configuration
None.
Example
The following example displays the bridge name of the LAN.
router06000a>lan show br1
lanhosts
The lanhosts command displays all the hosts on the lan. All the lanhosts
commands are listed here:
• lanhosts show all
• lanhosts show vlanX
lanhosts show all
To show all the lanhosts command, use the lanhosts show all command.
Parameter
None.