Cisco RV132W Command Line Interface Reference Guide

Configuration Commands
wan
Cisco RV34xx Router CLI Reference Guide 37
4
router06000a>vpn delete --name vpn1
vpn show
To show the vpn service, use the vpn show command.
Parameter
vpn show - Enter vpn show.
Default Configuration
None.
Example
The following example displays the vpn show command.
router06000a>vpn show
wan
The wan commands enable you to configure the wan interfaces for the router
within the command line. All the wan commands are listed here:
• wan {add | edit} interface atm portid.vpi.vci --linktype {eoa | pppoa | ipoa} -
-encap {llc | vcmux} --atmcat {ubr | cbr pcr | nrt vbr pcr scr mbs | rtvbr pcr scr
mbs}
• wan delete interface atm portid.vpi.vci
• wan {add | edit} service atm portid.vpi.vci --protocol {bridge | ipoe | pppoe |
ipoa | pppoa}
• wan {add | edit} service ptm --protocol {bridge | ipoe | pppoe}
• wan {add | edit} service eth --protocol {dhcp | static | pppoe | l2tp | pptp}
• wan delete service atm portid.vpi.vci --vlan
vlanID
• wan delete service ptm --vlan vlanID
• wlan delete service eth --vlan vlanID

Cisco RV132W Specifications

General

Device Type	Wireless Router
Wireless Standard	802.11n
Wireless Frequency Band	2.4 GHz
Maximum Wireless Data Rate	300 Mbps
VPN Support	Yes
Firewall	Yes
WAN Ports	1 x 10/100 Mbps
LAN Ports	4
Security Features	WPA/WPA2
Encryption	WPA2, WPA
Power Supply	12V DC
Operating Temperature	0 to 40 °C
Storage Temperature	-4 to 158°F (-20 to 70°C)
Operating Humidity	10% to 85% (non-condensing)
Storage Humidity	5 to 90% Noncondensing