Cisco RV180 Administrator's Manual

Configuring Networking
Configuring the WAN (Internet) Settings
Cisco RV180/RV180W Administration Guide 25
2
Configuring the IPv4 WAN (Internet)
STEP 1 Choose Networking > WAN (Internet) > IPV4 WAN (Internet).
STEP 2 Choose the type of Internet connection you have. The type of connection you have
determines the rest of the information you need to enter. See the sections below
for more information:
• Configuring Automatic Configuration (DHCP), page 25
• Configuring Static IP, page 26
• Configuring PPPoE, page 26
• Configuring PPTP, page 27
• Configuring L2TP, page 28
Configuring Automatic Configuration (DHCP)
If your Internet Service Provider (ISP) uses the Dynamic Host Configuration
Protocol (DHCP) to assign you an IP address, you receive a dynamic IP address
from your ISP.
To configure DHCP WAN settings:
STEP 1 Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
STEP 2 From the Internet Connection Type drop-down menu, choose
Automatic Configuration - DHCP.
STEP 3 Enter MTU information. (See Configuring MTU Settings, page 29.)
STEP 4 Enter MAC Address information. (See Configuring the MAC Address, page 29.)
STEP 5 Click Save.

Cisco RV180 Specifications

General

WAN Ports	1
LAN Ports	4
VPN Support	Yes
Wireless Support	No
Firewall	Yes
Device Type	VPN Router
VPN Tunnels	10
Authentication	MD5, SHA1
Power Supply	12V DC, 1A
Encryption	3DES, AES
VPN Protocols	IPSec
Operating Temperature	0 to 40 °C
Storage Temperature	-20 to 70 °C
Humidity	10% to 85% non-condensing
Dimensions	130 x 130 x 35 mm
Weight	0.28 kg