Cisco RV180 Administrator's Manual

Configuring Networking
Configuring the LAN (Local Network) Settings
Cisco RV180/RV180W Administration Guide 34
2
With DHCP enabled, the router's IP address serves as the gateway address to
your LAN. The PCs in the LAN are assigned IP addresses from a pool of
addresses. Each address is tested before it is assigned to avoid duplicate
addresses on the LAN.
For most applications, the default DHCP settings are satisfactory. If you want
another PC on your network to be the DHCP server, or if you are manually
configuring the network settings of all of your PCs, disable DHCP.
To configure the DHCP settings of the Cisco RV180/RV180W:
STEP 1 Choose Networking > LAN (Local Network) > IPv4 LAN (Local Network).
STEP 2 From the DHCP Mode drop-down menu, choose one of these options:
• None—Choose this option if the Cisco RV180/RV180W is not going to act as
a DHCP server.
• DHCP Server—Choose this option to configure the Cisco RV180/RV180W
to be a DHCP server and enter this information:
- Domain Name— (Optional) Enter the domain name for your network.
- Starting IP Address/Ending IP Address—Enter the first and last of the
contiguous addresses in the IP address pool. Any new DHCP client
joining the LAN is assigned an IP address in this range. You can save part
of the range for PCs with fixed addresses. These addresses should be in
the same IP address subnet as the Cisco RV180/RV180W's LAN IP
address.
- Primary DNS Server/Secondary DNS Server—DNS servers map
Internet domain names (for example, www.cisco.com) to IP addresses.
Enter the server IP addresses in these fields if you want to use different
DNS servers than are specified in your WAN settings.
- Lease time—Enter the duration (in hours) for which IP addresses are
leased to clients.
• DHCP Relay—Choose this option to configure the Cisco RV180/RV180W to
be a DHCP relay agent and enter the address of the remote DHCP server in
the Remote DHCP Server field. The relay agent transmits DHCP messages
between multiple subnets.
STEP 3 Click Save.

Cisco RV180 Specifications

General

WAN Ports	1
LAN Ports	4
VPN Support	Yes
Wireless Support	No
Firewall	Yes
Device Type	VPN Router
VPN Tunnels	10
Authentication	MD5, SHA1
Power Supply	12V DC, 1A
Encryption	3DES, AES
VPN Protocols	IPSec
Operating Temperature	0 to 40 °C
Storage Temperature	-20 to 70 °C
Humidity	10% to 85% non-condensing
Dimensions	130 x 130 x 35 mm
Weight	0.28 kg