Cisco SCE 8000 - Conventions

Contents
4
Cisco SCE 8000 10 GBE Installation and Configuration Guide
OL-29124-01
Multi-Gigabit Service Control Platforms (MGSCP) Topologies 6-4
The Optical Bypass Module 6-9
Optical Bypass Module Connectivity 6-9
Cabling the 10 GBE Line Interface Ports 6-11
XFP Module Cabling and Connection Equipment 6-11
Optical Device Maintenance 6-12
How to Cable the 10 GBE Line Interface Ports 6-13
Cabling the 10 GBE Line Interface Ports: Using the External Optical Bypass Module 6-14
Testing Connectivity: Examining Link LEDs and Counters 6-16
Examining the LEDs 6-16
How to View the Ten Gigabit Ethernet Port Status 6-16
How to View the Ten Gigabit Ethernet Counters 6-16
How to View the User Log Counters 6-17
How to Install a Service Control Application 6-18
Cascaded Systems 6-19
How to Install a Cascaded System 6-19
CLI Commands for Cascaded Systems 6-20
Topology-Related Parameters for Redundant Topologies 6-20
How to Configure the Connection Mode 6-21
How to Set the Link Mode 6-21
Monitoring a Cascaded System 6-22
CHAPTER 7 Basic Cisco SCE 8000 Platform Operations 7-1
Introduction 7-1
Starting the Cisco SCE 8000 Platform 7-2
Checking Conditions Before System Startup 7-2
Performing Complex Configurations 7-2
Starting the System and Observing Initial Conditions 7-3
What to Do Next 7-3
Final Tests 7-3
Verifying Operational Status 7-4
Viewing the User Log Counters 7-4
Viewing the Ten Gigabit Ethernet Port Status 7-4
Viewing the Ten Gigabit Ethernet Counters 7-5
Managing Cisco SCE 8000 Configurations 7-6
Viewing Configurations 7-6
Saving or Changing the Configuration Settings 7-8
Example for Saving or Changing the Configuration Settings 7-8
Restoring a Previous Configuration 7-9