Cisco SCE 8000 User Manual

Contents
7
Cisco SCE 8000 10 GBE Installation and Configuration Guide
OL-29124-01
Removing the Optical Bypass Module 9-33
Installing the Optical Bypass Module 9-33
Replacing the Optical Bypass Module Without Disrupting Traffic on the Link 9-33
APPENDIX A Using Optical Splitters with 10 GBE Links A-1
Introduction A-1
Supported Configurations A-1
Unsupported Configuration A-2
APPENDIX B CLI Commands to Verify a Successful Installation B-1
Introduction B-1
Basic Post-Installation Checklist B-2
CLI Command Output Samples B-3
show version B-4
show inventory B-7
show interface B-7
show system operational status B-8
show interface linecard B-8
show interface linecard connection-mode B-8
show interface linecard link mode B-8
show interface linecard external-bypass B-8
show RDR-formatter B-9
show interface linecard subscriber sm-connection-failure B-9
show ip rpc-adapter sessions B-10
APPENDIX C Cisco Service Control Engine System Log Messages C-1
Fatal Messages, Severity Level 2 C-2
Error Messages, Severity Level 3 C-4
Common Error Messages C-4
Control Card Error Messages C-5
Line Card Error Messages C-6
Informational Messages, Severity Level 6 C-7
Warning Messages, Severity Level 4 C-41

Cisco SCE 8000 Specifications

General

Brand	Cisco
Model	SCE 8000
Category	Switch
Language	English