Cisco SD2008T-NA User Manual

4-12
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 4 Configuring Controller SettingsWireless Device Access
Changing the Default Values for SNMP v3 Users
Using the GUI to Change the SNMP v3 User Default Values
Follow these steps to change the SNMP v3 user default values through the controller GUI.
Step 1 Click Management and then SNMP V3 Users under SNMP. The SNMP V3 Users page appears (see
Figure 4-3).
Figure 4-3 SNMP V3 Users Page
Step 2
If “default” appears in the User Name column, click Remove to delete this SNMP v3 user.
Step 3 Click New to add a new SNMP v3 user. The SNMP V3 Users > New page appears (see Figure 4-4).
Figure 4-4 SNMP V3 Users > New Page
Step 4
In the User Profile Name field, enter a unique name. Do not enter “default.”
Step 5 Choose Read Only or Read Write from the Access Mode drop-down box to specify the access level for
this user.
Step 6 In the next two fields, choose the authentication and privacy protocols to be used, and enter a password
for each.
Step 7 Click Apply to commit your changes.
Step 8 Click Save Configuration to save your settings.

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English