EasyManuals Logo

Cisco SD2008T-NA User Manual

Cisco SD2008T-NA
406 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
2-8
Cisco Wireless LAN Controller Configuration GuideCisco Access Router Wireless Configuration Guide
OL-6415-01OL-9141-03
Chapter 2 Using the Web-Browser and CLI Interfaces
Using the CLI
Follow these steps to log into the CLI through the serial port:
Step 1 Verify that your terminal emulator or DOS shell interface is configured with these parameters:
• Ethernet address
• Port 23
Step 2 Use the controller IP address to Telnet to the CLI.
Step 3 At the prompt, log into the CLI. The default username is admin and the default password is admin.
Logging Out of the CLI
When you finish using the CLI, navigate to the root level and enter logout. The system prompts you to
save any changes you made to the volatile RAM.
Navigating the CLI
The is organized around five levels:
Root Level
Level 2
Level 3
Level 4
Level 5
When you log into the CLI, you are at the root level. From the root level, you can enter any full command
without first navigating to the correct command level. Table 2-1 lists commands you use to navigate the
CLI and to perform common tasks.
Table 2-1 Commands for CLI Navigation and Common Tasks
Command Action
help At the root level, view system-wide navigation
commands
? View commands available at the current level
command ? View parameters for a specific command
exit Move down one level
Ctrl-Z Return from any level to the root level
save config At the root level, save configuration changes from
active working RAM to non-volatile RAM
(NVRAM) so they are retained after reboot
reset system At the root level, reset the controller without
logging out

Table of Contents

Other manuals for Cisco SD2008T-NA

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SD2008T-NA and is the answer not in the manual?

Cisco SD2008T-NA Specifications

General IconGeneral
BrandCisco
ModelSD2008T-NA
CategoryExtender
LanguageEnglish

Related product manuals