4-30
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring Voice and Video Parameters
c. Click the Detail link for the desired client to access the AP > Clients > Traffic Stream Metrics page
(see Figure 4-16).
Figure 4-16 AP > Clients > Traffic Stream Metrics Page
This page shows the TSM statistics for this access point and a client associated to it. The statistics
are shown in 90-second intervals. The timestamp field shows the specific interval when the statistics
were collected.
Using the CLI to Configure Voice Parameters
Follow these steps to configure voice parameters using the CLI.
Step 1 Make sure that the WLAN is configured for WMM and the QoS level is set to Platinum. See
“Configuring Quality of Service” section on page 6-17 for instructions.
Step 2 To disable the radio network, enter this command:
config {802.11a | 802.11b} disable network
Step 3 To save your settings, enter this command:
save config
To Next Page
Loading...
Need help?
General
