10-16
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Configuring Dynamic RRM
Step 2 Table 10-1 lists and describes the configurable RRM parameters. Follow the instructions in the table to
make any desired changes.
Table 10-1 RRM Parameters
Parameter Description
RF Group
Group Mode Determines whether the controller participates in an RF group.
Options: Enabled or Disabled
Default: Enabled
Group Mode Description
Enabled The controller automatically forms an RF group with
other controllers. The group dynamically elects a leader
to optimize RRM parameter settings for the group.
Disabled The controller does not participate in automatic RF
grouping. Rather, it optimizes its own access point
parameters.
Note Cisco recommends that controllers participate in automatic RF
grouping. However, you can disable this feature if necessary by
unchecking the check box. Note also, however, that you
override dynamic RRM settings without disabling automatic
RF group participation. See the “Overriding Dynamic RRM”
section on page 10-23 for instructions.
To Next Page
Loading...
Need help?
General
