6-11
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Step 7 If you chose PSK in Step 6, choose ascii or hex from the PSK Format drop-down box and then enter a
pre-shared key in the blank field. WPA pre-shared keys must contain 8 to 63 ASCII text characters or 64
hexadecimal characters.
Step 8 Click Apply to commit your changes.
Step 9 Click Save Configuration to save your changes.
Using the CLI to Configure WPA1+WPA2
Follow these steps to configure a WLAN for WPA1+WPA2 using the controller CLI.
Step 1 Enter this command to disable the WLAN:
config wlan disable wlan_id
Step 2 Enter this command to enable or disable WPA for the WLAN:
config wlan security wpa {enable | disable} wlan_id
Step 3 Enter this command to enable or disable WPA1 for the WLAN:
config wlan security wpa wpa1 {enable | disable} wlan_id
Step 4 Enter this command to enable or disable WPA2 for the WLAN:
config wlan security wpa wpa2 {enable | disable} wlan_id
Step 5 Enter these commands to enable or disable AES or TKIP data encryption for WPA1 or WPA2:
• config wlan security wpa wpa1 ciphers {aes | tkip} {enable | disable} wlan_id
• config wlan security wpa wpa2 ciphers {aes | tkip} {enable | disable} wlan_id
The default values are TKIP for WPA1 and AES for WPA2.
Step 6 Enter this command to enable or disable 802.1X, PSK, or CCKM authenticated key management:
config wlan security wpa akm {802.1X | psk | cckm} {enable | disable} wlan_id
The default value is 802.1X.
Step 7 If you enabled PSK in Step 6, enter this command to specify a pre-shared key:
config wlan security wpa akm psk set-key {ascii | hex} psk-key wlan_id
WPA pre-shared keys must contain 8 to 63 ASCII text characters or 64 hexadecimal characters.
Step 8 Enter this command to enable the WLAN:
config wlan enable wlan_id
Step 9 Enter this command to save your settings:
save config
To Next Page
Loading...
Need help?
General
