10-13
Cisco Wireless LAN Controller Configuration Guide
OL-1926-06OL-9141-03
Chapter 10 Configuring Radio Resource ManagementWireless Device Access
Enabling Rogue Access Point Detection
Step 3 Click the Detail link for an access point to access the All APs > Details page (see Figure 10-6).
Figure 10-6 All APs > Details Page
Step 4 Choose either local or monitor from the AP Mode drop-down box and click Apply to commit your
changes.
Step 5 Click Save Configuration to save your changes.
Step 6 Repeat Step 2 through Step 5 for every access point connected to the controller.
Step 7 Click Security > AP Authentication/MFP (under Wireless Protection Policies) to access the AP
Authentication Policy page (see Figure 10-7).
Figure 10-7 AP Authentication Policy Page
The name of the RF group to which this controller belongs appears at the top of the page.
To Next Page
Loading...
Need help?
General
