Cisco SD2008T-NA User Manual

3-21
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
Chapter 3 Configuring Ports and Interfaces
Configuring Ports
Step 3 Table 3-3 lists and describes the port’s configurable parameters. Follow the instructions in the table to
make any desired changes.
Power Over Ethernet (PoE) Determines if the connecting device is equipped to receive power
through the Ethernet cable and if so provides -48 VDC.
Values: Enable or Disable
Note Some older Cisco access points do not draw PoE even if it is
enabled on the controller port. In such cases, contact the Cisco
Technical Assistance Center (TAC).
Note The controller in the Catalyst 3750G Integrated Wireless LAN
Controller Switch supports PoE on all ports.
Table 3-3 Port Parameters
Parameter Description
Admin Status Enables or disables the flow of traffic through the port.
Options: Enable or Disable
Default: Enable
Note Administratively disabling the port on a controller does not
affect the port’s link status. The link can be brought down only
by other Cisco devices. On other Cisco products, however,
administratively disabling a port brings the link down.
Physical Mode Determines whether the port’s data rate is set automatically or
specified by the user. The supported data rates vary based on
controller type.
Default: Auto
Controller Supported Data Rates
4400 series Auto or 1000 Mbps full duplex
2000 and 2100 series Auto or 10 or 100 Mbps, half or
full duplex
WiSM Auto or 1000 Mbps full duplex
Catalyst 3750G Integrated
Wireless LAN Controller Switch
Auto or 1000 Mbps full duplex
WLAN controller module Auto or 100 Mbps full duplex
Link Trap Causes the port to send a trap when the port’s link status changes.
Options: Enable or Disable
Default: Enable
Ta b l e 3 - 2 Po r t S t a t u s
Parameter Description

Cisco SD2008T-NA Specifications

General

Brand	Cisco
Model	SD2008T-NA
Category	Extender
Language	English