Cisco SD2008T-NA - Chapter 4 Configuring Controller SettingsWireless Device Access

CHAPTER
4-1
Cisco Wireless LAN Controller Configuration Guide
OL-9141-03
4
Configuring Controller SettingsWireless Device
Access
This chapter describes how to configure settings on the controllers. It contains these sections:
• Using the Configuration Wizard, page 4-2
• Managing the System Time and Date, page 4-5
• Configuring a Country Code, page 4-6
• Enabling and Disabling 802.11 Bands, page 4-7
• Configuring Administrator Usernames and Passwords, page 4-7
• Configuring RADIUS Settings, page 4-8
• Configuring SNMP, page 4-8
• Changing the Default Values of SNMP Community Strings, page 4-9
• Changing the Default Values for SNMP v3 Users, page 4-11
• Enabling 802.3x Flow Control, page 4-13
• Enabling System Logging, page 4-13
• Enabling Dynamic Transmit Power Control, page 4-16
• Configuring Multicast Mode, page 4-16
• Configuring Client Roaming, page 4-17
• Configuring Voice and Video Parameters, page 4-22
• Configuring the Supervisor 720 to Support the WiSM, page 4-34
• Using the Wireless LAN Controller Network Module, page 4-35