Cisco SG500-28P Administration Guide

Cisco 500 Series Stackable Managed Switch Administration Guide 9
Contents
Chapter 16: Multicast 266
Multicast Forwarding 266
Typical Multicast Setup 267
Multicast Address Properties 269
Defining Multicast Properties 269
Adding MAC Group Address 271
Adding IP Multicast Group Addresses 273
Configuring IGMP Snooping 274
MLD Snooping 277
Querying IGMP/MLD IP Multicast Group 279
Defining Multicast Router Ports 280
Defining Forward All Multicast 281
Defining Unregistered Multicast Settings 282
Chapter 17: IP Configuration 284
Overview 284
Layer 2 IP Addressing 285
Layer 3 IP Addressing 286
IPv4 Management and Interfaces 287
IPv4 Interface 287
Defining an IPv4 Interface in Layer 2 System Mode 287
Defining IPv4 Interface in Layer 3 System Mode 288
IPv4 Routes 291
RIPv2 292
Access List 292
IPv4 VRRP Virtual Routers 292
ARP 292
ARP Proxy 293
UDP Relay/IP Helper 294
DHCPv4 Snooping/Relay 295
DHCPv4 Snooping 295
DHCPv4 Relay 295

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)