Cisco SG500-28P Administration Guide

24
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 460
Access Control
The Access Control List (ACL) feature is part of the security mechanism. ACL
definitions serve as one of the mechanisms to define traffic flows that are given a
specific Quality of Service (QoS). For more information see Quality of Service.
ACLs enable network managers to define patterns (filter and actions) for ingress
traffic. Packets, entering the device on a port or LAG with an active ACL, are either
admitted or denied entry.
This section contains the following topics:
• Access Control Lists
• Defining MAC-based ACLs
• IPv4-based ACLs
• IPv6-Based ACLs
• Defining ACL Binding
Access Control Lists
An Access Control List (ACL) is an ordered list of classification filters and actions.
Each single classification rule, together with its action, is called an Access Control
Element (ACE).
Each ACE is made up of filters that distinguish traffic groups and associated
actions. A single ACL may contain one or more ACEs, which are matched against
the contents of incoming frames. Either a DENY or PERMIT action is applied to
frames whose contents match the filter.
The device supports a maximum of 512 ACLs, and a maximum of 512 ACEs.

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)