Cisco SG500-28P Administration Guide

6
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 82
Administration: General Information
This section describes how to view system information and configure various
options on the device.
It covers the following topics:
• Device Models
• System Information
• Console Settings (Autobaud Rate Support)
• Rebooting the Device
• Routing Resources
• Monitoring Fan Status
• Defining Idle Session Timeout
• Pinging a Host
• Traceroute
Device Models
All models can be fully managed through the web-based switch configuration
utility.
NOTE Each model can be set to Layer 3 system mode by using the System Mode and
Stack Management page, except for the SG500X/ESW2-550X models that always
run in both Layer 2 and Layer 3 system mode.
When the device operates in Layer 3 system mode, the VLAN Rate Limit, and QoS
policers are not operational. Other QoS Advanced mode features are operational.
Only the SG500X/ESW2-550X models support Virtual Router Redundancy
Protocol (VRRP), and Routing Information Protocol (RIP).

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)