EasyManuals Logo

Cisco SG500-28P Administration Guide

Cisco SG500-28P
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #242 background imageLoading...
Page #242 background image
VLAN Management
VLAN Groups
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 224
13
GVRP Registration—Select to enable VLAN Registration using GVRP on
this interface.
STEP 7 Click Apply. GVRP settings are modified, and written to the Running Configuration
file.
VLAN Groups
VLAN groups are used for load balancing of traffic on a Layer 2 network.
Packets are assigned a VLAN according to various classifications that have been
configured (such as VLAN groups).
If several classifications schemes are defined, packets are assigned to a VLAN in
the following order:
TA G: If the packet is tagged, the VLAN is taken from the tag.
MAC-Based VLAN: If a MAC-based VLAN has been defined, the VLAN is
taken from the source MAC-to-VLAN mapping of the ingress interface.
Protocol-Based VLAN: If a protocol-based VLAN has been defined, the
VLAN is taken from the (Ethernet type) protocol-to-VLAN mapping of the
ingress interface.
PVID: VLAN is taken from the port default VLAN ID.
MAC-based Groups
MAC-based VLAN classification enable packets to be classified according to their
source MAC address. You can then define MAC-to-VLAN mapping per interface.
You can define several MAC-based VLAN groups, which each group containing
different MAC addresses.
These MAC-based groups can be assigned to specific ports/LAGs. MAC-based
VLAN groups cannot contain overlapping ranges of MAC addresses on the same
port.
Workflow
To define a MAC-based VLAN group:

Table of Contents

Other manuals for Cisco SG500-28P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG500-28P and is the answer not in the manual?

Cisco SG500-28P Specifications

General IconGeneral
Switching Capacity56 Gbps
Forwarding Rate41.67 Mpps
Flash Memory32 MB
Operating Humidity10% to 90% non-condensing
PoEYes
LayerLayer 2 and Layer 3
StackableYes
Power SupplyInternal
ManagementWeb-based GUI, CLI, SNMP
Jumbo Frame SupportYes
VLANs4096 VLANs
MAC Address Table Size16K entries
Dimensions440 x 44 x 350 mm
Operating Temperature0°C to 45°C
Ports28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)

Related product manuals