EasyManuals Logo

Cisco SG500-28P Administration Guide

Cisco SG500-28P
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Getting Started
Interface Naming Conventions
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 6
1
There are two hot links on the Getting Started page that take you to Cisco web
pages for more information. Clicking on the Support link takes you to the device
product support page, and clicking on the Forums link takes you to the Small
Business Support Community page.
Interface Naming Conventions
Within the GUI, interfaces are denoted by concatenating the following elements:
Type of interface: The following types of interfaces are found on the various
types of devices:
- Fast Ethernet (10/100 bits)These are displayed as FE.
- Gigabit Ethernet ports (10/100/1000 bits)These are displayed as
GE.
- Ten Gigabit Ethernet ports (10000 bits)These are displayed as XG.
- LAG (Port Channel)These are displayed as LAG.
- VLANThese are displayed as VLAN.
- TunnelThese are displayed as Tunnel.
Unit Number—Unit in stack. In standalone models this is always 1.
Slot NumberThe slot number is either 1 or 2. Slot number 1 identifies an
SG500, SG500X, or ESW2 -550 device. Slot number 2 identifies an SF500.
Interface Number: Port, LAG, tunnel or VLAN ID
Differences Between Sx500, SG500X and the ESW2-550X
Devices
This guide is relevant for both Sx500, SG500X and ESW2-550X devices. Notes are
provided when a feature is relevant for one but not both of these devices.
The following summarizes the differences between these devices:
The RIP and VRRP features are only supported on SG500X and ESW2-
550X devices running in standalone mode.

Table of Contents

Other manuals for Cisco SG500-28P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG500-28P and is the answer not in the manual?

Cisco SG500-28P Specifications

General IconGeneral
Switching Capacity56 Gbps
Forwarding Rate41.67 Mpps
Flash Memory32 MB
Operating Humidity10% to 90% non-condensing
PoEYes
LayerLayer 2 and Layer 3
StackableYes
Power SupplyInternal
ManagementWeb-based GUI, CLI, SNMP
Jumbo Frame SupportYes
VLANs4096 VLANs
MAC Address Table Size16K entries
Dimensions440 x 44 x 350 mm
Operating Temperature0°C to 45°C
Ports28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)

Related product manuals