EasyManuals Logo

Cisco SG500-28P Administration Guide

Cisco SG500-28P
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #302 background imageLoading...
Page #302 background image
17
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 284
IP Configuration
IP interface addresses can be configured manually by the user, or automatically
configured by a DHCP server. This section provides information for defining the
device IP addresses, either manually or by making the device a DHCP client.
This section covers the following topics:
Overview
IPv4 Management and Interfaces
IPv6 Management and Interfaces
Domain Name
Overview
NOTE SG500X devices always work in Advanced L3 mode, unless they are in Hybrid
mode (see Stack Unit Mode) when they act like Sx500 devices. The Sx500
devices, on the other hand, must always be set to work in Layer 2 or Layer 3 system
mode. Therefore, when this section refers to a device that works in Layer 3 system
mode, this refers to all SG500X devices in Native stacking mode and those devices
that have been manually set to Layer 3 system mode. When this document refers to
a device that works in Layer 2 system mode, this refers to all Sx500 devices and
SG500X devices (in Hybrid mode) that have been manually set to Layer 2 mode.
Some features are only available in Layer 2 or Layer 3 system mode, as described
below:
In Layer 2 system mode (only Sx500 devices), the device operates as a
Layer 2 VLAN-aware device, and has no routing capabilities.
In Layer 3 system mode, the device has IP routing capabilities as well as
Layer 2 system mode capabilities. In this system mode, a Layer 3 port still
retains much of the Layer 2 functionality, such as Spanning Tree Protocol
and VLAN membership.

Table of Contents

Other manuals for Cisco SG500-28P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG500-28P and is the answer not in the manual?

Cisco SG500-28P Specifications

General IconGeneral
Switching Capacity56 Gbps
Forwarding Rate41.67 Mpps
Flash Memory32 MB
Operating Humidity10% to 90% non-condensing
PoEYes
LayerLayer 2 and Layer 3
StackableYes
Power SupplyInternal
ManagementWeb-based GUI, CLI, SNMP
Jumbo Frame SupportYes
VLANs4096 VLANs
MAC Address Table Size16K entries
Dimensions440 x 44 x 350 mm
Operating Temperature0°C to 45°C
Ports28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)

Related product manuals