EasyManuals Logo

Cisco SG500-28P Administration Guide

Cisco SG500-28P
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #360 background imageLoading...
Page #360 background image
IP Configuration: RIPv2
How RIP Operates on the Device
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 342
18
The following illustrates the configuration of the metric offset for various
interfaces, based on port speed.
Configuring the Offset (Based on Port Speed)
Router rD can send data to rA via rB or rC. Since rC only supports Fast Ethernet
(FE) ports, and rB supports Gigabit Ethernet (GE) ports, the path cost from router
rD to router rA is higher via router rC (additional 4 to the cost path) as opposed to
the path via router rB (additional 2 to the cost path), Therefore, forwarding traffic
via routing rB is preferred. To achieve this, you configure a different offset (metric
value) on each interface based on its line speed.
See Offset Configuration for more information.
Passive Mode
Transmission of routing update messages over a specific IP interface can be
disabled. In this case, the router is passive, and only receives the updated RIP
information on this interface. By default, transmission of routing updates on an IP
interface is enabled.
See RIPv2 Settings on an IP Interface for more information.

Table of Contents

Other manuals for Cisco SG500-28P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SG500-28P and is the answer not in the manual?

Cisco SG500-28P Specifications

General IconGeneral
Switching Capacity56 Gbps
Forwarding Rate41.67 Mpps
Flash Memory32 MB
Operating Humidity10% to 90% non-condensing
PoEYes
LayerLayer 2 and Layer 3
StackableYes
Power SupplyInternal
ManagementWeb-based GUI, CLI, SNMP
Jumbo Frame SupportYes
VLANs4096 VLANs
MAC Address Table Size16K entries
Dimensions440 x 44 x 350 mm
Operating Temperature0°C to 45°C
Ports28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)

Related product manuals