Cisco SG500-28P Administration Guide

Administration: Discovery
Configuring LLDP
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 142
9
• Left to Send (Bytes)—Total number of available bytes left for additional
LLDP information in each packet.
• Status—Whether TLVs are being transmitted or if they are overloaded.
STEP 2 To view the overloading details for a port, select it and click Details.
This page contains the following information for each TLV sent on the port:
• LLDP Mandatory TLVs
- Size (Bytes)—Total mandatory TLV byte size.
- Status—If the mandatory TLV group is being transmitted, or if the TLV
group was overloaded.
• LLDP MED Capabilities
- Size (Bytes)—Total LLDP MED capabilities packets byte size.
- Status—If the LLDP MED capabilities packets were sent, or if they were
overloaded.
• LLDP MED Location
-
Size (Bytes) —Total LLDP MED location packets byte size.
-
Status —If the LLDP MED locations packets were sent, or if they were
overloaded.
• LLDP MED Network Policy
-
Size (Bytes) —Total LLDP MED network policies packets byte size.
-
Status —If the LLDP MED network policies packets were sent, or if they
were overloaded.
• LLDP MED Extended Power via MDI
-
Size (Bytes) —Total LLDP MED extended power via MDI packets byte
size.
-
Status —If the LLDP MED extended power via MDI packets were sent, or
if they were overloaded.
• 802.3 TLVs
-
Size (Bytes) —Total LLDP MED 802.3 TLVs packets byte size.
-
Status —If the LLDP MED 802.3 TLVs packets were sent, or if they were
overloaded.

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)