Cisco SG500-28P Administration Guide

IP Configuration: RIPv2
Configuring RIP
353 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
18
- Any—All IP addresses are included.
- User Defined—Enter an IP address.
• Source IPv4 Mask—Source IPv4 address mask type and value. The
following options are available:
- Network Mask—Enter the network mask (for example 255.255.0.0).
- Prefix Length—Enter the prefix length.
• Action—Action for the access list. The following options are available:
- Permit—Permit entry of packets from the IP address(es) in the access
list.
- Deny—Reject entry of packets from the IP address(es) in the access list.

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)