Cisco SG500-28P Administration Guide

Security
Defining Management Access Method
383 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
20
A caution message displays if you selected any other access profile, warning you
that, depending on the selected access profile, you might be disconnected from
the web-based configuration utility.
STEP 3 Click OK to select the active access profile or click Cancel to discontinue the
action.
STEP 4 Click Add to open the Add Access Profile page. The page allows you to configure
a new profile and one rule.
STEP 5 Enter the Access Profile Name. This name can contain up to 32 characters.
STEP 6 Enter the parameters.
• Rule Priority—Enter the rule priority. When the packet is matched to a rule,
user groups are either granted or denied access to the device. The rule
priority is essential to matching packets to rules, as packets are matched on
a first-match basis. One is the highest priority.
• Management Method—Select the management method for which the rule
is defined. The options are:
- All—Assigns all management methods to the rule.
- Teln e t—Users requesting access to the device that meets the Telnet
access profile criteria are permitted or denied access.
- Secure Telnet (SSH)—Users requesting access to the device that meets
the SSH access profile criteria, are permitted or denied access.
- HTTP— Users requesting access to the device that meets the HTTP
access profile criteria, are permitted or denied.
- Secure HTTP (HTTPS)—Users requesting access to the device that
meets the HTTPS access profile criteria, are permitted or denied.
- SNMP—Users requesting access to the device that meets the SNMP
access profile criteria are permitted or denied.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the device if the user matches the settings in
the profile.
- Deny—Denies access to the device if the user matches the settings in
the profile.
• Applies to Interface—Select the interface attached to the rule. The options
are:

Cisco SG500-28P Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.67 Mpps
Flash Memory	32 MB
Operating Humidity	10% to 90% non-condensing
PoE	Yes
Layer	Layer 2 and Layer 3
Stackable	Yes
Power Supply	Internal
Management	Web-based GUI, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4096 VLANs
MAC Address Table Size	16K entries
Dimensions	440 x 44 x 350 mm
Operating Temperature	0°C to 45°C
Ports	28 (24 x 10/100/1000 PoE+ ports, 4 x 10/100/1000/SFP combo ports)