12
D1509712 User Guide
Cisco TelePresence SX10, SX20
Produced: June 2017 for CE9.1
All contents © 2010–2017
Cisco Systems, Inc. All rights reserved.
You may call someone who is not
listed in your list of contacts by
keying in their name, address or
number using the virtual keyboard.
Anyone you have previously called
will appear in the Recents list and
you may then add any of them
to your list of Favorites. This is
described in the section Contacts.
Call Using Video Address
The procedure when using an IP
type video address to call someone
is similar. Just key in the address
and use
*
(the asterisk button
in the lower left corner on the
remote control) as separator. The
system will interpret this as a valid
IP address separator so that the
video address appears as correctly
entered.
Place Call Using Name, Number or IP-Address
Video Calls
About Placing Calls
Make sure Call is selected (the leftmost
icon along the bottom of the screen) and
press OK on the remote control or press
the green Call button on the remote control.
To use the virtual keyboard, navigate down
to and about the keyboard and select
characters. Press OK to select a character.
To enter numbers just press the
corresponding keys on the remote control.
Then press the green Call button to place
the call.
Use the Cursor keys to navigate to the
Search or Dial eld at the top of the menu.
Press OK.
Press the red End Call button on the
remote control, or use the Cursor keys to
select End and then press OK to terminate
the call.
1 2 3
4 5 6
To Next Page
Loading...
Need help?
General
Weight and Dimensions
