Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router

Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the VPN Settings
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 111
5
Setting Up and Configuring Remote Groups
The Remote Group Setup section of the VPN > IPSec VPN window displays
settings for configuring the remote groups of VPN tunnel connections.
To set up and configure a remote group, follow these steps:
STEP1 Click VPN > IPSec VPN.
STEP 2 Configure Remote Group Setup settings.
• Remote Security Gateway Type—There are two types. They are IP Only, IP
+ Domain Name (FQDN) Authentication. The type of Remote Security
Gateway should match with the Local Security Gateway Type of VPN
devices in the other end of tunnel.