Finding Out MAC and IP Addresses
Windows 2000 or XP Instructions
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 209
D
Windows 2000 or XP Instructions
STEP1 Click Start and Run. In the Open field, enter cmd. Press the Enter key or click the
OK button.
STEP 2 At the command prompt, enter ipconfig /all. Then press the Enter key.
STEP 3 Write down the Physical Address as shown on your computer screen. It is the
MAC address for your Ethernet adapter. This appears as a series of numbers and
letters. The MAC address/Physical Address is what you will use for MAC address
cloning or MAC filtering.
For the Router’s Web-based Utility
For MAC address cloning, enter the MAC Address in the MAC Address field or
select Clone My PCs MAC.
Click Save Settings to save the MAC Cloning settings or click the Cancel
Changes button to undo your changes.
To Next Page
Loading...
