Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router User Manual

Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the Administration Settings
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide 127
5
To configure System Logs for the router, follow these steps:
STEP1 Click Administration > Log.
STEP 2 Configure the system logs for the router:
• Log Setting
- Log Level—Select the log levels that the router should record.
- Outgoing Log—Select Enable to cause all outgoing packets to be
logged. You can then click View Outgoing Table to display information on
the outgoing packets including Source IP, Destination IP, and Service/Port
number.
- Incoming Log—Select Enable to cause all incoming packets to be
logged. You can then click View Incoming Table to display information on
incoming packets including Source IP, Destination IP, and Service/Port
number.
• Email Alerts
- Email Alerts—If enabled, an e-mail is sent when the number of DoS
events exceeds the defined threshold or the total events number exceed
100. If enabled, you must provide the e-mail address information.
Level Severity Name Description
7 LOG_DEBUG Debug-level message
6 LOG_INFO Information messages only
5 LOG_NOTICE Normal but significant condition
4 LOG_WARNING Warning conditions
3 LOG_ERR Error conditions
2 LOG_CRIT Critical conditions
1 LOG_ALERT Immediate action needed
0 LOG_EMERG System unusable

Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router Specifications

General

Brand	Cisco
Model	WRVS4400N - Small Business Wireless-N Gigabit Security Router
Category	Wireless Router
Language	English