Citizen CL-S6621 - Page 66

Operation Panel
CL-S6621 2-52
Mach Cut Pos +000dots
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
Mach Peel Pos +000dots
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
Mach Hor Pos +00dots
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
AutoCal Mode ON
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
SeeThrough Sensor 0.0
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
Reflect Sensor 0.0
Save=(PAUSE) Next Digit=(FEED) Change value=(STOP) Exit=(MODE)
SeeThrough Sensitivity Low
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Reflect Sensitivity Low
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Darkness Rate High
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Double Heat Menu OFF
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
PowerOn Head Check ON
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Ribbon End Detection Quick
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Parallel Error Output ON
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
USB Serial Number OFF
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Auto Exec Print ON
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Config Print Layout Standard
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Print Preference Darkness
Save=(PAUSE) Change value=(STOP) Exit=(MODE)
Note: In the actual printing, the cursor “^” will be printed instead of “ (underline)”.