© 1999-2017 Citrix Systems, Inc. All rights reserved. p.173https://docs.citrix.com
4. Add nodes to the cluster:
1. Click Add Node.
2. In the Add Node dialog box, configure the parameters required for adding a cluster node. For a description of a
parameter, hover the mouse cursor over the corresponding field.
3. Click Next to view the configuration summary.
4. Click Finish to add the node to the cluster.
5. Repeat steps a through d to add another node to the cluster.
After creating the cluster, you must configure it by accessing it through the cluster IP address.
Note: To get an updated list of NetScaler clusters, each of which has at least one NetScaler instance of the SDX
appliance, use the Rediscover option.
To add a NetScaler instance that exists on one SDX appliance to a cluster configured on another SDX
appliance
1. Log on to the SDX appliance from which you want to add the NetScaler instance.
2. On the Configuration tab, navigate to NetScaler, and then click Clusters.
3. Click Add Node.
4. In the Add Node dialog box, configure the parameters required for adding a cluster node. For a description of a
parameter, hover the mouse cursor over the corresponding field.
Note: Make sure the values of the Cluster IP address and Cluster IP Password parameters are for the cluster to which
you want to add the node.
5. Click Next to view the configuration summary.
6. Click Finish to add the node to the cluster.
To Next Page
Loading...
